Shaker Reproduction Table

  • Advertise with us
Project by Ben posted 01-19-2016 09:52 PM 874 views 0 times favorited 8 comments Add to Favorites Watch

I was inspired to build this based on a photo I saw of the original made in Hancock Shaker Village.
I deviated slightly, mixing Cherry and Maple, and added the hand turned ebony drawer pull.
The original also had the reversed tails/pins on the drawer, which I copied, although I did two tails instead of three.

Sliding dovetails connect the legs to the pedestal. These were cut with a router in a slide/jig that I built. Handcut dovetails on the drawer and yoke.

Thanks for looking.

8 comments so far

View Joe Lyddon's profile

Joe Lyddon

10039 posts in 3960 days

#1 posted 01-19-2016 11:33 PM

COOL table…

-- Have Fun! Joe Lyddon - Alta Loma, CA USA - Home: ... My Small Gallery:"

View TraylorPark's profile


212 posts in 1506 days

#2 posted 01-20-2016 12:36 PM

Very cool table. Congrats on a great project.


-- --Zach

View KnottyTimber's profile


3 posts in 1086 days

#3 posted 01-23-2016 03:17 PM

Very nice job.

View Mike Throckmorton's profile

Mike Throckmorton

124 posts in 1572 days

#4 posted 01-23-2016 03:28 PM

I found the title of your post disturbing, but then I remembered Shakers did not in fact reproduce.

Table looks fantastic, though. Pedestal is beautiful!

-- You are never complete, you just draw a line where done is and stop at that line.

View helluvawreck's profile


30164 posts in 2774 days

#5 posted 01-23-2016 03:49 PM

It’s a wonderful table and you did a fine job on it.

helluvawreck aka Charles

-- If a man does not keep pace with his companions, perhaps it is because he hears a different drummer. Let him step to the music which he hears, however measured or far away. Henry David Thoreau

View Rick_M's profile


11126 posts in 2287 days

#6 posted 01-23-2016 09:08 PM

Different, I haven’t seen that Shaker table before.


View a1Jim's profile


116906 posts in 3484 days

#7 posted 01-23-2016 09:41 PM

Down right pretty .very nice work Ben.

-- Custom furniture

View oldnovice's profile


6550 posts in 3275 days

#8 posted 01-24-2016 06:19 AM

Looks like one of Norm’s projects!
Very nice project, thanks for sharing!

-- "I never met a board I didn't like!"

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics