LumberJocks

Scrap Wood Butcher Block Hanging Shelf

  • Advertise with us
Project by kryptix posted 11-08-2018 02:32 PM 424 views 2 times favorited 5 comments Add to Favorites Watch

I’ve been looking for projects to clear out the scrap bins lately, and here’s one of them.

Made a panel with all sorts of scraps, but it wasn’t thick enough for the back of this piece. Made another panel with pine and used the cutoffs from the ends of the scrap wood panel to create a backer panel but to still allow me to bevel the top and bottom without revealing that its not one solid piece of wood. The ends are dominoed in for a bit more strength. Dadoed the shelf, then cut in a taper on both sides with the track saw. Then glued on maple accent strips on both sides and beveled the maple for a lighter look. Shelves are eucalyptus and have the same bevel. Top shelf is held in with 6 neodymium magnets that are lined up with the 6 screws holding it to the wall.

Finish is tung oil, shellac, then spar varnish (hopefully helps protect the colors)





5 comments so far

View majuvla's profile

majuvla

13234 posts in 3044 days


#1 posted 11-08-2018 02:40 PM

I like those various wood stripes. Nice groove joint solution -I hope it will be sufficient.

-- Ivan, Croatia, Wooddicted

View kryptix's profile

kryptix

100 posts in 767 days


#2 posted 11-08-2018 03:12 PM


I like those various wood stripes. Nice groove joint solution -I hope it will be sufficient.

- majuvla

The bottom 3 shelves are actually screwed in from the back with 5×3 inch screws which should be more than sufficient. Didn’t glue them because cross grain I was a little worried about wood movement working them loose.

Top shelf the magnets hold well enough that you have to pull pretty hard to get it loose so I don’t think it will be an issue.

View swirt's profile

swirt

3312 posts in 3148 days


#3 posted 11-08-2018 04:04 PM

Very clever.

-- Galootish log blog, http://www.timberframe-tools.com

View KimAccurso's profile

KimAccurso

349 posts in 316 days


#4 posted 11-08-2018 11:45 PM

Great solution to highlight the woods in your scrap bin. I like it so much I’m going to keep this in the back of my head as a project to do this winter to empty out my own scrap bin!

-- Kim - imperfection is the pursuit of perfection

View michelletwo's profile

michelletwo

2762 posts in 3192 days


#5 posted 11-09-2018 09:49 AM

clever

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com